ASCOM POTH DRIVER DOWNLOAD

Starting with the basics, please - do I need to download it, or do I already have it? Checking or un-checking them has no influence on POTH behaviour. When Starry Night installed, it went in with "Administrator" level rights. The mount seems to get a GPS Fix without difficulty this way and it saves minutes once the roll-off roof is finally pulled back previously I used to wait until roof was open before starting up the LX, this was more from a worry that the scope might spring into movement and hit the observatory roof. Then after a few minutes that connection fails and I have to close CdC etc. This 32 bit only driver won't work in a 64 bit application even though it is correctly registered as a 32bit COM driver. A new nightime session will be required to test the overall behaviour of the full system using MetaGuide.

Uploader:	Meztikora
Date Added:	23 December 2004
File Size:	40.6 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	11820
Price:	Free* [*Free Regsitration Required]

In this case both pier side LEDs will light up yellow.

Use this to set the location of the serial trace log and to turn tracing on and off. It seemed to happen when I was trying to make a connection to my Aurora Cloud Sensor coincidence, or not?

Like most websites, SGL uses cookies in order to deliver a secure, personalised service, to provide social media functions and to analyse our traffic.

Conditions where poor wind, declining sky transparency, frost on ST sensorbut the results seemed to show that the autoguiding was ironing out the arc pot bumps in RA with s period that have been affecting the scope. Buying SGP is part of this new start. Just below that selector, click Settings Clear skies to ya Jim.

For the time being I'm trying to get both software options working and available. Gina, I hate these iffy connections. It is very important that Asco, notion of when the mount will flip is the same as the mount's notion.

This can happen when a driver is a simple implementation, or when an older version 1 telescope driver is being used. Sign up for a new account in our community.

EQASCOM - Help! "POTH" or "Generic" Hub - Discussions - Software - Stargazers Lounge

You may need to ensure that all applications accessing the mount have the same privilege. In the mean time I am trying to gather information. I can configure AstroMC to not do the dome position calculation itself. By jstrong in forum Astronomy Beginners Forum.

For those drivers that do, you can capture a trace of the serial traffic to and from the device by using serial tracing. Share Share this post on Digg Del. Results 1 to 6 of 6. Add Thread to del.

POTH Information

IncClientCount And when finished, I use: See the Correcting for Problems also in the menu on the left. I find that it does what I need it too and normally hassle free. Thanks Jared, you are right ofcourse with your advice to try it out myself. I did find if I didn't use one of the two hubs then I couldn't connect two applications that wanted mount control at the same time whereas with one of the hubs I could.

Geometry parameters for GEMs located in ascpm are defined at the following link: Originally Posted by admin.

POTH setup help?

This is the download link Keith. The dome and focus areas will be revealed. I have tried both but to date have failed to see any significant difference. Using the Ascom POTH Hub was sort of a solution but it was critical with the order in which to connect the various components. This 32 bit only driver won't work in a 64 bit application even though it is correctly registered as a 32bit COM driver. TeleAPI configuration picture from http: Canon D; Various EPs, etc.

Most astronomy applications are at present Jan compiled as 32 bits and will work with 32 bit only drivers, even on 64 bit versions of Windows. Across the flip, the dome goes the short way and gets there first.